How to install the board of Chint Photovoltaic

Where can I find the Chint power systems user manual?

The manual will be periodically updated or revised due to the product development or improvement. The latest version of this manual can be acquired via the website at 1. IMPORTANT SAFETY INSTRUCTIONS (SAVE THESE INSTRUCTIONS) Please read this user manual carefully before installation of the inverter.

Why should I buy a CPS grid-tied PV inverter?

Thanks for choosing this CPS Grid-tied PV Inverter. This PV Inverter is a high performance and highly reliable product specifically designed for the North American Solar market. If you encounter any problems during installation or operation of this unit, first check this manual before contacting your local dealer or supplier.

How to install a CPS inverter?

290.0 (11.4in.) 1. Hang the inverter onto the mounting bracket as shown in Figure 3-6; Manual mounting: One person can safely lift the inverter and mount it onto the bracket. The main enclosure of the CPS inverters is 22kg (48.5 pounds). 2. Install the wire-box: Remove screws securing the bulkhead cover at the top of the wire-box.

How do I inspect a CPS inverter?

It is advised that customers contact the CPS hotline: 855-584-7168 for further advice and to arrange schedule for CPS service personnel to perform inspection of inverter on site. Ensure that the mounting structure (wall, rack, roof, etc.) is suitable to support the weight of the inverter. Follow the mounting guidelines below:

Can a CPS inverter be left outside?

CPS advises against leaving inverters mounted outdoors for an extended period of time (more than 90 days) and/or allowing inverters exposed to cycles of freezing temperature without both DC and AC power connected to the inverters under normal operation.

How to turn on a PV inverter?

Make sure the DC open circuit voltage of input strings is less than 1000V. ) Turn on the AC circuit breaker. ) Turn on the DC circuit breaker. (Skip these two steps if there are no circuit breakers.) ) Switch the DC Switch to the “ON” position. When the energy supplied by the PV array is sufficient, the LED of inverter will light up.