Photovoltaic Epoxy Board Manufacturer Address

What is E132 PV & led encapsulation epoxy?

Ossila's E132 PV & LED Encapsulation Epoxy can be used as an adhesive for organic light-emitting diodes and organic photovoltaics without damaging the polymer or cathode. In conjunction with a glass coverslip, it can provide a robust barrier against ingress of oxygen and water, thus providing extended lifetimes for measurement and storage.

Can you use epic s7469 adhesive for photovoltaic panels?

Our adhesives can be used not only for assembly of photovoltaic panels but also for attaching the panel frames to the mounting racks. Epic S7469 is a two-component urethane adhesive designed to provide superior adhesion to a variety of thermoplastic substrates.

How do you encapsulate epoxy?

For small substrates (up to 2 cm 2 ), place a single drop of epoxy dispensed from the end of a pipette onto the surface of the substrate, and place a glass cover-slip over the top. The encapsulation epoxy will then spread under the weight of the cover-slip over the course of a few seconds.

What is a light-curable epoxy?

A light-curable epoxy suitable for solar cell and LED encapsulation. Sets at wavelengths of up to 350 nm and is safe for use with most organic materials. approx. 600 μl per scale up sized substrate (60 ml ~ 100 scale up substrates)

Does epoxy encapsulate flexible substrates?

Our encapsulation epoxy has been shown to encapsulate flexible substrates during an Innovate UK funded investigation. Encapsulating the devices protects them against degradation by oxygen and moisture once removed from the glove box.

Can encapsulation epoxy be used in a glove box?

Ensure the active area and metal cathode are covered. Place in a light-box and expose until hardened. Please also note: If used in a glove box, the encapsulation epoxy should be allowed to de-gas any absorbed oxygen/water for at least 24 hours prior to entering the glove box.