Installation of purlin connectors for photovoltaic brackets

What is solar panel support with Z profiles and purlins brackets?

Solar power systems use the sun’s rays as a high-temperature energy sources to produce electricity in a thermodynamic cycle. Thereby we have to introduce some solar panel support with Z profiles and purlins brackets, which are hot galvanized steel material for use in long time with better surface and the best cost during the system construction.

What is a purlin through hole clamp?

Bottom access, Purlin Through Hole clamps are Type 304 Stainless steel for higher strength and durability. The clamp allows for direct PV module mounting to purlins and other structural members. The patented pre-assembled clamps eliminate handling small parts on the job site and provide for a faster installation.

How should a purlin flange be connected?

Any such loadings must be connected to the purlin web by using hangers or other means. Never attach loads to the purlin lips. Attachments to the purlin flange must be within 25mm of the web. Connection design should follow the rules within AS/NZS4600, including a check on bearing of the purlin. Loads should not be suspended from wall girts.

What are fastensol solar panel fixings & solar panel mounting rails?

Our range of Fastensol offers premium Solar Panel Fixings & Solar Panel Mounting Rails, a cutting-edge solution for efficient solar installations. These high-quality components ensure secure panel attachment and easy alignment, maximising energy output.

What bolts do I need for a purlin?

Normally M12 bolts are required for purlins between 100 and 250, whilst M16 bolts are needed for 300 and 350 purlins. Each bolt requires integral washers. The bolt strength grade (4.6 or 8.8) should be specified by the design engineer to conform with the Stramit® Purlins, Girts & Bridging – Product Technical Manual.

Do I need a bridging inspection before installing a purlin?

It is imperative that this be resolved immediately and prior to installation. Purlins and Girts supplied by Stramit will be made from high tensile galvanised steel. Final inspection of the installed purlin, girt and bridging system should check for correct bolting of laps and that bridging is correctly in place.