Aux Photovoltaic Inverter Instructions

What is the use and installation manual for Aurora photovoltaic inverter?

Use and installation manual Page (PVI-10.0/12.0-I-OUTD (-S)-400 Rev:1.3) INTRODUCTION This document is a technical description of the AURORA photovoltaic inverter; the aim of this document is to provide the installer and user with the necessary information regarding the installation, operation and use of AURORA.

How to install PV modules in a microinverter?

You can install individual PV modules in any combination of Module quantity, orientation, different type and power rate The Ground wire (PE) of the AC cable is connected to the chassis inside of the Microinverter,potentially eliminating the installation of grounding wire (check local regulation).

How to mount an Aurora inverter?

WALL MOUNTING The AURORA inverter should be mounted vertically, with a maximum inclination from the vertical of 5°. Any larger inclination from the vertical could reduce the power conversion capability with a consequent reduction in energy harvesting. • Drill Ø 10 mm holes to a depth of 75 mm in line with the support bracket’s xing holes (det.

How do I install a PVI I-OUTD (S-400) inverter?

Step 1: Remove the front cover of the inverter as shown in section 3.4.2. Step 2: Lay down the AC cables from the inverter terminal box to the AC disconnector. Use and installation manual Page (PVI-10.0/12.0-I-OUTD (-S)-400 Rev:1.3) Step 1: Remove the front cover of the inverter as shown in section 3.4.2.

What are the statuses of a PV inverter?

Normally there will be three statuses during the operation (refer to the LED indications): Waiting: Conditions: The initial DC voltage of the PV strings is greater than the Min. DC input voltage, but is lower than the DC start-up input voltage. Inverter cannot start-up normally and cannot feed power into utility grid either.

How to set up an inverter?

• Switch the integrated switch (versions –S and –FS) to the ON position or close the external switches: If the input voltage applied to one of the two input channels is greater than the minimum starting voltage, the inverter will start up. 10.1. Selection of grid standard (“Nation”)