Photovoltaic panel unpacking and hoisting method diagram

How to unpack PV modules?

Unpacking of PV modules should always be done in the vertical manner by two persons as shown in the diagram. Also care should be taken for falling over one module to the other inside the packing box. Modules should be stored in a dry and ventilated environment to avoid direct sunlight and moisture.

How to pack solar PV modules?

Inside the box each module is placed in vertically. Put the module into the carton from one side with protector on four corners. Citizen Solar recommends that two people should load into and remove the modules from the pack carton for solar PV modules.

How to install PV modules in hot and humid environment?

PV modules install under hot and humid weather condition. PV modules installation site is under long-term humid environment such as water floating application. To reduce the risk of PID, on the modules DC connection site, it is recommended to connect the negative to ground.

How to unload & store PV modules?

UNLOADING, UNPACKING & STORAGE At receipt of PV modules, verify the product details as it had been ordered. Packing list pasted outside the box contains all details including the serial no of modules. It is recommended to unload the packing box by using forklift only.

Can you walk on a LONGi Solar PV module?

DO NOT stand or walk on PV modules. Prior to beginning installation, review the Installation Manual for LONGi Solar PV Modules. Do not carry a module alone; always use two people to lift and carry. Do not drill holes in the frame of the module. In addition to invalidating the product warranty, this will also reduce

Can PV modules be wired in series?

Modules can be wired in series to increase voltage. Connect positive terminal of one module to the negative terminal of the next module. PV modules only with the same rating should be used in series and parallel connections. Connect modules in parallel to increase current.