Photovoltaic awning bracket installation diagram

How to install an awning on a wall bracket?

To install an awning on a wall bracket, follow the installation distances above, put the original bolts on the wall brackets and tighten them, and finally fasten all expansion bolts.

How to assemble a DIY Retractable Awning?

To assemble a DIY Retractable Awning, hold tightly and stretch slowly until completely open when the elasticity is very strong on the arms. Tie the arms together during assembly. Do not stand face front of the awning while cutting off binds between the arms. Proper location and fastening of the wall brackets is critical, please refer to the instructions in the manual.

How do you install a square bar awning?

With proper help, lift the awning (with fabric Roll tube above the Square Bar) into the brackets and position so the ends line up with end points marked on the wall. Push the square bar into the brackets and secure with one retaining bolts in each bracket. Be sure to insert the bolt from the bottom of the bracket up.

How many brackets do I need for a 16 ft awning?

For 16 ft wide awnings, we recommend installing four brackets supplied at the locations (a), (b), (d) and (e). (See Page. 10) For 20 ft wide awnings, use five brackets supplied at the locations (a), (b), (c), (d), (e). (See Page. 10) On the chalk line you have marked on the house, mark the left and right ends of the awning.

How do you install an awning on a roof?

Measure the placement of the awning using a chalk line. Brackets should be place as close to the edge of the roof line as possible and may have to hang over gutter so that you can still use the EZ-Adjustable Pitch. Also make sure the bracket placement will not be in the same location as the arm shoulder assembly.

Can awning pitch be adjusted after installation?

The awning pitch (angle) can be adjusted after installing the awning. See page 19. Note: When making the decision on the mounting height, remember that the awning requires 9 inches of unobstructed area along the whole length of the awning to fit the mounting brackets on your wall. see figure 3.